Icicle Hitch (With the Loop) Knot – Step by Step How to Tie It

The icicle hitch is perfect for securing a line to a rod. This is a slide and grip knot, meaning the load can be moved from one line to another.

This is the loop method variation. You can find the “end method” of tying it here. Below are the steps for the loop method…

Steps 1 through 5. The first few steps are the same as would be if tied with the end. Make a succession of turns away from the end. Then lay the working end over the pole, nearer to the end of the pole than the turns are:

icicle loop knot step 2
icicle loop knot step 3
icicle loop knot step 4
icicle loop knot step 5

Step 6. Take the working end under the pole, to lie next to the standing end. Note that a large bight has been left in the working part:

icicle loop knot step 6

Step 7. Twist the bight over itself, putting the side nearer the end of the pole over the side further from it:

icicle loop knot step 7

Step 8. Retaining the twist in the bight, lay the bight underneath the working and standing ends:

icicle loop knot step 8

Step 9. Slip the bight over the end of the pole:

icicle loop knot step 9

Step 10. Snug the bight up against the rest of the knot:

icicle loop knot step 10

Step 11. Pull on the standing end to tighten the knot:

icicle knot with a loop final

I have found that the extra slack in the middle of the knot (which is difficult to pull out before the force is applied) when using the loop method makes the knot elongate a lot more than it would otherwise, so it may be best to use the other method unless absolutely necessary or where safety is not a concern.

icicle hitch loop knot Pinterest image

The post Icicle Hitch (With the Loop) Knot – Step by Step How to Tie It appeared first on Survival Sullivan.

Source: survivalsullivan.com

- -